2-wire zc102 smoke detector comptaible with all conventional fire alarm control panel
General Description
The device is photoelectronic detector uses a state of-the-art optical sensing chamber.This detector is designed to provide open area protection and to be used with most conventional fire alarm control panel.
Two LEDs on each detector provide local 360degree visible alarm indication. they flash every 3~5seconds indicating that power is applied and the detector is working properly.The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. the detector can be reset only by a momentary power interruption.
Features and Benefits
1.compatible with all the conventional fire alarm control panel
2.Unpolarized wire input
3.Wide range of operating voltages
4.Unique optical sensing chamber
5.Built in microprocessor intelligent software
6.Two LEDs blink standby, provide 360 visibitly
7.Insect-resistant screening
8.Drift compensation and smoothing algorithms
9.Remote indicator LED can be connected.
Technical Specifications
System voltage:24VDC(9~28VDC)
Standby current:60uA@24VDC
Alarm current: 30mA@24VDC
Operating temperature range: -10C to 50C
Operating Humidity Range: 10% to 93% Relative humidity,Noncondensing.
Latching Alarm: Reset by momentary power interruption.
INSTALLATION GUIDELINES
All wiring must be installed in compliance with the National Electrical code,applicable state and local codes,and any special requirements of the local Authority having jurisdiction.
